Gf-signet 9900-1BC Batch Controller System Manual de usuario descargar pdf (Pagina 15)

159900-1BC Batch Controller Manual

Menu System

This is the normal display

(when batch is running).

BATCH Setup Checklist

1. Set the Units of Measure in Input Menu.

2. Set Flow Timebase in Input Menu.

3. Set Sensor Type (Freq or S

L) in Input Menu.

4. Set Batch Size in Input Menu.

5. Set K-Factor (pulses per Unit Volume) from

Flow Sensor manual in CAL Menu.

6. Set up relay functions and other settings for

your own application.

VIEW Mode Menu - Batch Running

Stop Running Batch Press ENTER to stop batch that is running.

Note: ENTER button stops batch in any screen on VIEW Mode.

Time Left displays estimated time remaining (in minutes) until batch is completed.

Percent Complete displays percent remaining or percent completed of running batch.

Count direction based on COUNT UP/DOWN setting in INPUT menu.

Flow Rate displays current ﬂ ow rate of running batch.

Output Current displays the output loop current in milliamperes (mA).

Source Volume displays the calculated remaining source volume. Shown if SOURCE VOLUME is ON.

Relay Status displays relay status for Relays 1, 2 and 3. One of three states (OFF, ON, PLS) for each

relay will be displayed.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Sin comentarios

Gf-signet 9900-1BC Batch Controller System Manual de usuario Pagina 15